TTAF Super Power Board
Energy Saving Program
Product design is to meet energy efficiency and energy saving goals.
• IR Remote Control
Use your own IR remote control to turn on this PowerPort.
• Loading Current Display
The digital display to show current consumption status.
• Automatically Shut Down
The PowerPort will automatically detect current consumption of connected electrical
appliances. It shuts down the power of switched outlets once these connected
electrical appliances turn into standby model or reach the factory setting of power
• Power Surge Protection
Protects your electrical equipments from voltage spikes.
• EMI/RFI Noise Filtration
Eliminates the interference and increases the performance of electrical appliance
• LED Indication
There are three LED to indicate device status (AC Power,Surge Protection, and IR
Status.LEDs to indicate device status - AC Power, Surge Protection, and IR Status.
The installation steps are as follows:
1.Connect the electrical appliances to Always On outlet or Switched outlet.
Note: The Always On outlets will provide constant power. The switched outlets will be
controlled by PowerPort and the On or Off will depend on the current consumption
status. Details please refer to specifications.
2.Connect the telephone RJ11 cable, Ethernet Cat 5 RJ45 cable and coaxial cable to
PowerPort for surge protection.
1. Make sure the power source is properly grounded, then use the power cord supplied
with the PowerPort to connect it to the power source.
2. If your installation requires a different power cord than the one supplied with the
power supply, be sure the cord is adequately sized for the switch's current
requirements. In addition, be sure to use a power cord displaying the mark of the
safety agency that defines the regulations for power cords in your country. The mark is
your assurance that the power cord can be used safely with this product